e682 solid green st...
 
Notifications
Clear all

e682 solid green status light

3 Posts
2 Users
0 Reactions
1,316 Views
imbluenote
Posts: 1615
Topic starter
(@imbluenote)
Noble Member
Joined: 15 years ago
[#27814]

i have an e682 that i build and had initally tested after that and it all worked o.k. My pixel plans died out this year so i was going to use the 682 as an e1.31 bridge for this year instead.

I tried to connect to it via PC last night and i couldn't. When i power it up i get the 3.3V and 3,4 yellow lights, the red light, and ,with no ethernet cable connected, the green status light stays on solid. I have tried to reset and force to the different IP modes and I till get the same with the status lights and i cannot connect. as i mentioned i have connected to it and configured it before and ran pixels off of it, and didn't have this problem then.

I have an e680 and i can connect to that just fine with same cables, PS, router, etc. so it seems to me it is something with the 682 itself, but i cannot figure out what.

Any suggestions?


2 Replies
Posts: 853
(@roterhead)
Prominent Member
Joined: 15 years ago

Does the green light blink a few times after power up?


Reply
imbluenote
Posts: 1615
Topic starter
(@imbluenote)
Noble Member
Joined: 15 years ago
Roterhead wrote:Does the green light blink a few times after power up?

No it doesn't it come on at the same time as the red light and stays on with or without an Ethernet cable hooked up


Reply
Share: