Technicolor quality...
 
Notifications
Clear all

Technicolor quality?

256 Posts
45 Users
0 Reactions
83.3 K Views
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago
[#27802]

For those that have them. .. what are you seeing as compared to the other pixels?


255 Replies
Posts: 230
(@trcons)
Reputable Member
Joined: 17 years ago

I'm having trouble with mine. About 15% have failed burn in.

Tom


Reply
dsmjuggalo
Posts: 663
(@dsmjuggalo)
Prominent Member
Joined: 15 years ago

I have 250 of them lining windows. I have one bulb that I had to tighten the cover down really tight on to get it to stay lit, and two others that stay blue when no sequence is running. so 3 out of 250 that im gonna have to replace. I really like how bright they are, they seem brighter way brighter than my pixabulbs. On the flip side I have about 150 pixabulbs and not a single problem out of one of them.


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

Tom when you say 15 percent... Are those strings or individual pixels


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

I was doing some tests on the strings that are going up on the highest peak of the house and I found my ECG-P2 had problems. The refresh rate was finicky and if it was over or under the lights would act funny, lockup on white, etc. I hooked that same strand up to my E6804....didn't seem to have a problem then....not sure whats going on. I know the E6804 auto sets the refresh rate based on the number of pixels and pixel type. Where the ECGP2 allows MANUAL setting...so I am sure this is operator error.


Reply
Page 1 / 52
Share: