My current set up is i have 3 renard controllers set to universe 1 of my e1.31 and with channels 1-60 in vixen 3. I have my pixels set to universe 2 on the e1.31 with starting channel 1 to 510 an universe 3 with starting channel 1 to 510. These are going ro be daisy chained together so i am not sure if my e1.31 setup is correct with 2 universes. I can get one strand of 50 working but the second controller does not work.
Does the universe selection in vixen 3 control the physical output of the e1.31 and they need to match? I have three px1's i plan on daisy chaining, but i figured once i get two working the third would be prettty easy. I know i have missed information needed but i am not for sure what it is.
I am basically trying to get three px1 controllers and 500 pixels working in vixen 3 through a diyledexpress e1.31 alomg with my standard renards that are 60 channels.
How would it be possible to daisy chain across universes ?
each universe from the bridge requires its own path .
That could be part that i am getting confused. Do i set 1 e1.31 controller in vixen 3 with enough channels for all the controllers and pixels connected to those controllers? The issue i dont sem to grasp is the channels only being able to be 1-512 on one controller and adding more for added channels. I am sure i am stating something wrong. sorry for the basic questions, but this is my first year with any of this.
I do not know how you do this within V3 , i would gather that each e1.31 device needs its own configuration as far as universe structure .
try settting up a e1.31 device etc for each universe .
If the controllers are daisy chained, does it matter in the e1.31 setup how many channels are set up or is it determined by the program itself. I wonder if that is my issue?
Basically, the start address and channel count in the e1.31 setup does not matter as long as there is a controller setup with the crrect baude and output. Am i correct in this thinking?
