im trying to hook up renard to 681 upgrade. i hooked up data - and ground together and data to data and tested in config page but nothing lightss up. Any one try this yet.
The basic setup is Data(E681) to Data+(RS485) and Clock(E681) to Data-(RS485) and ground(E681) to ground(RS485). Look at the last two pages of the E682 manual for more details.
A regular E681 only does logic level 485, not true RS485 voltages. You may need to get one of budude's adapter boards for true RS485 signaling.
jklingert wrote:The basic setup is Data(E681) to Data+(RS485) and Clock(E681) to Data-(RS485) and ground(E681) to ground(RS485). Look at the last two pages of the E682 manual for more details.A regular E681 only does logic level 485, not true RS485 voltages. You may need to get one of budude's adapter boards for true RS485 signaling.
wow! great resources will have to read before i go to bed 🙂
Can i keep my regular firmware for this? And where you able to tell it test 1 to see if it works in config page.
Test 1 in the E681 is for pixels only that are connected to the E681 directly, not something regular renard or dmx. When you set the E68x up for renard or DMX it just outputs regular renard or DMX signals sort of like the E1.31 Bridge does.
so how do you test to see if there working . Or are you telling my i need to use lsp or vixen to test only?
boarder3 wrote:so how do you test to see if there working . Or are you telling my i need to use lsp or vixen to test only?
You could use your sequencing software or there are free E1.31 test tools you can use.
Actually when running the E68x pattern tests, there is output on the Renard configured ports. I found this out quite by surprise when testing both my GECE pixels and my SS24 connected to my E682. It seems that when test pattern on is selected on the E68x device it signals what would be the 1st colour in the sorting order for pixels (Red?) to turn on at full brightness so in the case of a Renard(s) controller the result seems to be that it tells channels 1, 4, 7, 10, 13....and so on to turn on. The second test pattern turns on the next set of channels on the Renard controller(s) 2, 5, 8, 11....and so on. The third test pattern would then turn on the next set of channels on the Renard(s), channels 3, 6, 9, 12....etc.
This has been my experience running firmware 4.026 on a E682. I am also using budude's (mentioned in an earlier post
by jklingert) adapter board to connect my SanDevices to my SS24.
I don't know what different revisions of the E68x boards/firmware would mean for you results but thought I'd share.
Shane
so your using dmx firmware? or renard
My SS24 is running the stock Renard firmware that it shipped with when I purchased it last year from Wayne's group buy.
