Technicolor Pixels
 
Notifications
Clear all

Technicolor Pixels

140 Posts
31 Users
0 Reactions
43.4 K Views
Posts: 17
(@rdebolt)
Active Member
Joined: 16 years ago
dougd wrote:The problem is bad pixels!

At this point I have to agree!


Reply
timon
Posts: 2149
Topic starter
(@timon)
Noble Member
Joined: 16 years ago

I'm wondering if the failing nodes are mostly TM1804's? The WS2811 being a constant current device only uses a resistor on the red channel and that just to balance the load on the chip. The TM1804 being a constant voltage device requires three resistors and they set the current.

I've seen the mold with the PCB in place and there is not much room on the PCB to get that many parts on the board. If a direct substation was made the TM1804 is going to get overly stressed. We won't know till Steven can open one up so I'm waiting to hear what he finds.


Reply
Posts: 347
(@dougd)
Reputable Member
Joined: 19 years ago

Well as mentioned earlier. I am seeing the exact same things out of my pixels. 97 strings of 50. They are 2811 bullet nodes. At least 50% of the strings have failed. I have a shoebox full of cutout pixels where I have tried to fix the strings to no avail.


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

The reason I asked is that there are SO MANY variables that can cause what's in the video...sometimes a diagram of how you hooked things up can help. Might be nothing...could be a simple ground issue. My first attempt to fix that would be to disconnect each string and go one by one plugging them back in...I will say this...I had a strip go white, it was a data issue.


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago
dougd wrote:Well as mentioned earlier. I am seeing the exact same things out of my pixels. 97 strings of 50. They are 2811 bullet nodes. At least 50% of the strings have failed. I have a shoebox full of cutout pixels where I have tried to fix the strings to no avail.

Silicone injection molded or epoxy encapsulated?


Reply
Page 12 / 28
Share: