Technicolor Pixels
 
Notifications
Clear all

Technicolor Pixels

140 Posts
31 Users
0 Reactions
43.4 K Views
Posts: 17
(@rdebolt)
Active Member
Joined: 16 years ago
MindTrik wrote:rdebolt, PM me your specs and setup. Also, while my TC's are working, FOR NOW, I purchased the TC's to put on my roof line and peaks because those are the most inaccessible areas to get to with a failure. SO instead of using what I had LAST year on the roof and peaks..I put the TC's on and used my old ones on the windows and wreaths so I could get to them....time will tell if this was a STUPID move or not.

You can see my videos and specs in above post. Let me know if you want more info!

Roger


Reply
Posts: 17
(@rdebolt)
Active Member
Joined: 16 years ago

I have been in contact with Seven010. He wants some nodes to checks and information. I am waiting first to see what Ray is going to do before sending him anything. My plan at this time is to send him an entire string with failures, not just a node or 2.


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

Can you draw a diagram of your connections? From the controller to the PS and out to the pixels. I spotted what looks like a bad pixel right of the get go..Also, your going to have to start unplugging strings and tackle this one at a time. OR you could start turning on pixels using XLights 5-10 pixels at a time until you find where the problem is. Your problem is DATA...guarantee it.


Reply
Posts: 17
(@rdebolt)
Active Member
Joined: 16 years ago
MindTrik wrote:Can you draw a diagram of your connections? From the controller to the PS and out to the pixels. I spotted what looks like a bad pixel right of the get go..Also, your going to have to start unplugging strings and tackle this one at a time. OR you could start turning on pixels using XLights 5-10 pixels at a time until you find where the problem is. Your problem is DATA...guarantee it.

I have already replaced about 60 nodes. Spent 2 days making everything on just 1 section of my roof work. 3 days later I had many more bad. Cannot all be data.... Lights are stuck on with NO data. No expert here, but that has to be a bad pic that is turning on nodes. Not sure what kind of diagram that you want. There are 3 wires on a pigtail connected to the controller and a 3 pin plug at the end. Then 3 pin connector on the strings (Factory installed) plugged in and screwed to the node string.

I am driving my TM1804 bullet node Megatree (32 strings of 60 nodes) the EXACT same way and they are running like clock work!

This post sounded argumentative and I did not mean it that way. Just stating what I am seeing.


Reply
Posts: 347
(@dougd)
Reputable Member
Joined: 19 years ago

The problem is bad pixels!


Reply
Page 11 / 28
Share: