What firmware are you running in them? I am using 3.0 with Shelby's flash tool. The 4 that I tested all did the same thing. Loaded fine and connected dhcp, but lost everything on a power cycle.
If the configuration settings that you are setting in the web GUI are not persisting on the ESP, that's the classic symptom of the Puya flash chip problem. While I haven't personally seen this problem (I don't have any puya modules) what I've read is that you can actually read the "PUYA" name on the flash chip of the ESP01 module. You may need a magnifying glass, but you should be able to actually identify the chip and know you have a bad module.
jchuchla wrote:If the configuration settings that you are setting in the web GUI are not persisting on the ESP, that's the classic symptom of the Puya flash chip problem. While I haven't personally seen this problem (I don't have any puya modules) what I've read is that you can actually read the "PUYA" name on the flash chip of the ESP01 module. You may need a magnifying glass, but you should be able to actually identify the chip and know you have a bad module.
The puya chip = ver 2 is significantly visually smaller than esp version 1 .
The site he purchased from provides in depth videos on this also .
I have both the puya and the original chipped esp modules .
The modules are not bad or defective , the puya just does not function as expected with ver 3 of the pixelstick firmware .
The terminology is subjective. You're right, they're not defective, but they are not suitable. Modules with Puya chips are indeed bad for the purpose of ESPixelStick. And also for pretty much any ESP application that's based on and compiled from the Arduino ESP environment.
I'm not sure if the amazon listing is still the same as it was when he posted the link. But the product currently being sold under that link is the "Version II" and you can clearly see PUYA printed on the flash chip. Those aren't going to work as ESPixelSticks.
They will work with the an earlier version of the firmware , link in other thread.
