SanDevices controll...
 
Notifications
Clear all

SanDevices controller site

9 Posts
6 Users
0 Reactions
2,527 Views
Posts: 230
Topic starter
(@oldandslow)
Reputable Member
Joined: 16 years ago

The site is up and running today.


Reply
cnbales
Posts: 503
(@cnbales)
Honorable Member
Joined: 15 years ago

The ip address of the controller you are entering is not a registered domain name. The language that you're using makes me think that you believe that it is a hosted website. That is not the case. You may need to make sure that you computer is on the same subnet to access the controllers interface through the ip address.


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago
oldandslow wrote:I can't get the controller site to stay up. I used two computers and have the same problem.

I went to the default IP address 192.168.1.206 to try and change my E682 configuration and it will not stay open. It pops opens then closes right away.

Anyone else have this problem? any suggestions? I am running the old 4.051 version.
thanks
John

What is your local IP address?


Reply
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago
cnbales wrote:The ip address of the controller you are entering is not a registered domain name. The language that you're using makes me think that you believe that it is a hosted website. That is not the case. You may need to make sure that you computer is on the same subnet to access the controllers interface through the ip address.

I agree, this may be the issue. Go to the command line (CMD) and type ipconfig /all. You are looking for the IPv4 address. It should be 192.168.1.xxx. If it is not, then your subnet is not the same and it will not connect. Type "exit" (no quotes) to exit the command line.


Reply
Page 2 / 2
Share: