I can't get the controller site to stay up. I used two computers and have the same problem.
I went to the default IP address 192.168.1.206 to try and change my E682 configuration and it will not stay open. It pops opens then closes right away.
Anyone else have this problem? any suggestions? I am running the old 4.051 version.
thanks
John
Are you connecting by wifi or ethernet? When you say it "closes right away", what's on the screen afterwards?
With a cat 5 cable. It said site can't be found. If I hit refresh it will pop up 1 more time and will not refresh again.
I have had that issue before...
If I could offer what i did..
on the board itself (with power on)
you will want to FORCE a temporary IP address. Depending on how your christmas display is setup you will need to set the temporary IP accordingly.
press and hold the PROG button (after a few seconds the red and green LEDS will flash)
1 will display the current IP in blinks (not recommended)
2 forces ip address 2.2.2.2
3 forces ip address 10.10.10.10
4 forces ip address 169.254.74.73
5 forces ip address 192.168.0.206
6 forces ip address 192.168.1.206
7 forces ip address 192.168.2.206
and so on up to 15
so, since i use a subnet of 192.168.10.xxx
i press the PROG button and let it flash 15 times to get the forced ip address of 192.168.10.206
after it is set. open the temporary address
from the page check that you have the latest firmware, and set or confirm the IP address you want for your controller.
(the latest posted firmware is 4.081-01 and can be downloaded HERE) however, I have posted the latest version 5.030-1 below
I found that I have lots of issues with using the FWLOADER also on his site HEREso i update my boards using the Propeller flasher (I recommend HERE(This is the manufacturer and they have very good Customer service or HERE(Amazon))).
the reason i believe the boards do that is the firmware crashes occasionally when power is applied to the boards when the boards have older firmware.
after you get the IP address set, and verify the FW, etc you need to reboot your board. I suggest that prior to that, create a shortcut on your (Christmas display) desktop for easy access
notes:
I use UNICAST whereas lots of folks use MULTICAST (its up to you, I found more stability having the info packets sent JUST to this board rather then all 20-30 boards in my display).
If you havent downloaded the manual yet, i would strongly suggest that you do so HERE.
hope this helps
Ken
The site is up and running ok today.
