Sandevice E682 Powe...
 
Notifications
Clear all

Sandevice E682 Power Problem

70 Posts
8 Users
0 Reactions
13.2 K Views
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

so if I put some pressure on the top right corner it starts to work fine I have tried to resolder those points with no luck


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

has to be somewhere you have a bad connection if it works with pressure


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

do you have a magnifier if so look over the board with the best magnification you can and see if you missed any solders or if any of them don't look like good solder points


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

can you get another new picture of the bottom of the board maybe a couple from dif angles of board and 1 straight on


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

Jim at sandevice messaged me

Sounds like the push button is stuck down. Was this built from a kit? If so check for solder bridges around the push button switch and 472 resistor network. If a kit could be a bent pin on the CPU not fully in the siocket.

-jim-


Reply
Page 12 / 14
Share: