Sandevice E682 Powe...
 
Notifications
Clear all

Sandevice E682 Power Problem

70 Posts
8 Users
0 Reactions
13.2 K Views
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

have you tried going to command prompt and typing in ipconfig/all and see if it shows you 682 listed and the ip it has


Reply
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

no it doesn't show me it at all and I can login to a different networking device and see everything that is connected and it is not on there at all


Reply
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

these are what the lights are doing

I attached a video


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

To do override1,
press and hold PROG until the RED/GREEN LEDs come on together for the first time, then release PROG.
Override 1 will blink out the controller’s IP address on the LEDs. For each digit the green LED will come on.
While it’s on, the RED LED will blink out the number value of that digit.
If the GREEN LED goes on and off with no flashes from the RED LED, that’s a 0.


Reply
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

I just tried that and both LEDs just blink together

I should only have 2 jumpers one for the power and the other for the eprom right

Do I need to have any other jumpers in place


Reply
Page 10 / 14
Share: