Question about "cha...
 
Notifications
Clear all

Question about "channels"

34 Posts
16 Users
0 Reactions
8,906 Views
Posts: 50
(@blarson)
Trusted Member
Joined: 11 years ago
didjareally wrote:Not sure where it currently stands as I have not kept up with the progress, but originally with ver. 5 firmware on the e682 it was supposed to raise the pixel count up to 2700

That's in Unicast right?


Reply
Posts: 50
(@blarson)
Trusted Member
Joined: 11 years ago

When I am in Xlights it says I have a max of 7 universes with 510 Channels per universe for a total of 3570 channels or 1190 pixels and it says it's in multicast. Can I run unicast in Xlights to get more pixels out of my e682?


Reply
smeighan
Posts: 2595
(@smeighan)
Famed Member
Joined: 15 years ago

Xlights can run unicast or multicast

Sent from my iPhone using Tapatalk


Reply
Posts: 317
(@spyder)
Reputable Member
Joined: 11 years ago
BLarson wrote:So there would be a total of 1992 pixels. Can I do this with an e682? I am using XLights to control it. I have a Alphapix 16 v2 which I bought to control the the lights on my house, but I could always use that for my tree if I needed too. But $$.

Thanks in advance for the help.

Yes you can. The difference between multicast and unicast is that when on multicast the data is sent to each IP address on the network. With Unicast you set you IP on the controller and in your sequencer and the data for that address is only sent to that address. Plus as mentioned if you upgrade the firmware on your E682 you can push a few more pixels with it.


Reply
Page 4 / 4
Share: