xLights uses both multicast and unicast. Multicast runs up to 7 universes - 3570 channels and unicast runs up to 12 universes - 6120 channels.
Is unicast for more than 1 board, what is the difference, can I run my 4050 pixels under unicasrt on 1 e682?
Thanks
Multicast broadcast all channels over the network where as unicast only broadcasts information germaine to the set specific controller eg. ip 192.168.1.207. I use unicast because I have over 13000 channels and want the info specific for each controller to be sent to said controller. When you get into p10 matrices and lots of pixel if you use multicast it can really slow down the network.
For maximizing universe/channel counts per e682 controller, unicast has that nice advantage over multicast.
Thanks - I made a matrix with 1350 pixels X 3 = 4050 channels. I setup multicast for 7 channels - finally - and got it running.
Can I setup unicast and enter the IP address of the e682 so I can run 2 more channesl?
covewi wrote:Thanks - I made a matrix with 1350 pixels X 3 = 4050 channels. I setup multicast for 7 channels - finally - and got it running.
Can I setup unicast and enter the IP address of the e682 so I can run 2 more channesl?
Yes. Enter the ip for each e682. Each one will have 12 universes 1-12 by default. Make sure you change xlights to 510 channels per universe for all universes. Channel values in xlights are absolute so even though the universes start again at 1 for each controller your first universe will be channel 6121 if you use 12 universes of 510
