Notifications
Clear all

UniCast

25 Posts
9 Users
0 Reactions
7,791 Views
Posts: 485
(@jerry-rigs)
Honorable Member
Joined: 11 years ago

Best practice (more like a rule) is to only manually assign IP addresses that are outside of the DHCP pool. Let the router (DHCP server) manage it's pool and let the human manage the rest.

My advice is to always manually assign IP addresses to controllers and externally label the controllers with their assigned IP address.

Caveat: a network pro can nitpick everything I am about to say but this is intended to address your current level of knowledge

EdK wrote:...regardless of my router's particular DHCP pool of addresses, I thought that when a router dynamically assigns a connected device an IP address from the pool, it will not assign an IP address that is already being used.

Home routers assign or loan out IP address from their DHCP pool. They will not assign the same IP address to two devices at the same time, but a device can be manually configured to be any IP address and the router has no say about it. If the device is manually configured with an IP that happens to be in the DHCP pool, the router doesn't know and can "double" assign that address.

EdK wrote: I'm guessing it's a best practice to stay away from using any DHCP pool addresses for a controller

It's my best practice but people using multicast may say otherwise.

I use unicast so I manually to assign IP addresses to each of my controllers and in that case, the IP addresses I assign are outside of the DHCP pool.

Others use multicast. In that arrangement, letting the router auto-assign IP addresses from the DHCP pool can be OK. I think its makes configuring the controller via its webpage harder because you have to figure out the controller's IP address before you can configure it. DHCP assigned IP addresses tend to be "sticky" so the controller IP addresses -may- not bounce around on you.

I prefer unicast but advocating unicast over multicast or vice-versa is likely to start a religious war.

EdK wrote: .. if I ... assign a DHCP pool address to a controller, will that cause an issue?

Simple answer: Sooner or later, yes.
The real answer is more complex and I'm tired of typing.


Reply
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago

It's been a while since posting and wouldn't you know its because I have a problem. I brought out the matrix for Halloween. Hooked up to the MAC and theres nothing.
However with the PC everything is fine. Both are setup he same in Unicast.

Any ideas Mac users?

Thanks - I look forward to the up coming holidays and everyones posts.


Reply
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago

A new 2016 unicast /e682 question. I currently have this unicast setup and the matrix works perfectly.

Screen Shot 2016 11 02 at 6.13.17 PM

Can I add 3 more universes and use them to control something other than the matrix - like a wreath or candy cane - at the same time as the matrix?
That might add another 150 rgb pixels.

Thanks


Reply
Posts: 485
(@jerry-rigs)
Honorable Member
Joined: 11 years ago

Yes.


Reply
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago

I can't find anything on how to assign a universe or channels to another model. I already have the matrix setup and working but would like to control the wreath too.
Any suggestions or references? Thanks

Screen Shot 2016 11 03 at 3.36.47 PM

I have the matrix setup and a wreath. What happened - you can see the single top row of the matrix has the colors and acts like the single strand of the wreath?
Is is a model setup problem, a preview only problem or will it show up in real time?

Screen Shot 2016 11 03 at 4.18.16 PM

Reply
Page 5 / 5
Share: