Thanks for the help. So I think I've got the pic prgramming down. I was opening the hex file in mplab as opposed to importing it. Now I get the Rx led lit(solid on) when I'm connected, however all of the pixels are on solid white. Any ideas here?
mbasile35 wrote:Thanks for the help. So I think I've got the pic prgramming down. I was opening the hex file in mplab as opposed to importing it. Now I get the Rx led lit(solid on) when I'm connected, however all of the pixels are on solid white. Any ideas here?
Try a full restart. Power off the controllers and restart Vixen/the PC and see if that clears the all white. My new PX1 did the same thing and a full power cycle cleared it. Good luck!
Hey all,
just wanted to update you guys and thank you for your help. My initial issue, as I said, was that when I was choosing the hex file to program the pic in mplab, I was opening the file instead of importing the file. The issue with the all white pixels was that I had the data line connected to the clock output. Luckily no harm was done to my strings and I've got the lights up and working on the house. Thanks again to everyone for you input and time!
mbasile35 wrote:. The issue with the all white pixels was that I had the data line connected to the clock output.
I did that also...after over 100 connections made for my controllers, first hiccup and i was stumped till I saw my mix up
