Problems with PX1
 
Notifications
Clear all

Problems with PX1

9 Posts
4 Users
0 Reactions
2,702 Views
mbasile35
Posts: 53
Topic starter
(@mbasile35)
Trusted Member
Joined: 15 years ago
[#39358]

Hey everyone

I'm having some trouble getting 2 PX1's up and running. The main problem is that I'm not seeing the Rx LED on either board light up when connected to Vixen. I've tested the connection on a know good Ren32 so I know that isn't the problem. What's really confusing me is that I had one board working with the default firmware as a test. I then attempted to change the firmware to allow for control of 150 pixels. I uploaded to new firmware to the pic via ICSP, and nothing happened. I then tried to flash the orginal firmware back onto the pic, but still nothing happened. Some things to note:

-My original test used Vixen 3
-I had the board connected to 150 pixels w/o injection since I knew only 50 would be controlled
-This first test was successful so I wired in power injection after the first 50 pixels
-I changed to firmware to control 150 pixel, and programmed the pic using a clone pickit3 and the ICSP
-I reran the original test without success
-I reflashed the original firmware
-I reran the original test without sucess
-I got tried of going back and forth from my computer to the controller so I took the controller off the house and started testing on my bench
-I powered up both controllers and wired in 1 string of 50 pixels that was switched back and forth to test both controllers
-Reran my test without success
-Wired up a ren32, dropped the baud rate to 57600 (I was running the px1s at 115200)
-Created a new test sequence and ran it which worked on the ren 32
-Reconnected the PX1, bumped the baud rate back up and ran the test
-The first pixel changed to green which was inconsistent with the test sequence

So I'm really at a complete loss here. I have no idea what to do. Any ideas would really be appreciated


8 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

did you follow the directions on how too program the px1 pic it is a little different than a normal pic


Reply
mbasile35
Posts: 53
Topic starter
(@mbasile35)
Trusted Member
Joined: 15 years ago

Come to think of it, I follow instructions the first time I programmed it which was when it worked, but for the other times I just assumed I was doing it right. Perhaps I missed a little step. Do you happen to know the process or have a link to instructions?


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

let me find his directions


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago
Reply
Page 1 / 2
Share: