Pixel set up questi...
 
Notifications
Clear all

Pixel set up question

14 Posts
6 Users
0 Reactions
4,450 Views
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago
Xenia wrote:The E682's run directly off of you computer or Pi, but if you want more than one E682 you hook a switch up to the pi or computer and then run multiple. You can run a rennard network off either a serial port on a computer or you can run a renard network off of an of an E1.31 Bridge or an empty cluster on an E682. You do not need a bridge to run an E682. Most of us will setup a show network to make all of this easier to manage.

Yes you really don't need the bridge. Just switches to the E682's and then run your Renard/DMX boards off the one output off of the 682.


Reply
Posts: 181
Topic starter
(@mangrove)
Estimable Member
Joined: 16 years ago

I think I'm understanding this a little better now. I went to the wiki and reread the documentation on E1.31 networking. Looks like I put a network switch or router after the computer/Pi then run cat5 to each controller/bridge. With this configuration it appears the number of devices you can have are limited by the network switch. I guess in my setup I'll put a 8 port switch along with a bridge which should give me all the capacity I need.

I understand I don't need the bridge, but I'll probably use it anyway as that will give me more options for future stuff.

Thanks for the patience and help!


Reply
Posts: 1115
(@11bravo)
Noble Member
Joined: 14 years ago

Is a switch device the same as a router or a bridge?


Reply
Xenia
Posts: 1358
(@xenia)
Noble Member
Joined: 15 years ago

In this case most are saying bridge and meaning either the RPM Bridge or DIYLED Express Bridge, both of which are controllers and not a network bridge. A router is usually also a switch but a switch is only a switch. Most wifi access points are both routers and a switch depending how they are used and setup.

Mangrove, you can expand the number of ports just by daisy chaining switches so if your start with an 8 port switch and hook another 8 port switch into the first you will have 14 ports available for devices. 8 + 8 = 16 - computer/pi/router connect and switch #2 connected into Switch #1.


Reply
Page 3 / 3
Share: