I suppose you could use your bridge, but just remember the 682's will send out a DMX universe each.
The E1.31 is very simple, just think of it as another network.
Mine is Pi---->switch------>E682------->pixels
____________________________------->Renard
__________________------>E680------->Pixels
__________________------>E680------->Pixels
682's need to be cat-5 connection straight from computer/pi, split signal through a hub then hub to e131 bridge to renard ss24's from my understanding after searching for hours on this subject as i'm setting this up this year myself. So it will be
computer/pi ------- network hub ------ e682
this off of hub -------------------- \---- e682
this off of hub ----------------------\e131 bridge
So effectively you would be using 3 ports on hub, 2 ports on bridge. If someone could confirm I would appreciate.
The setup I was thinking of would be as follows:
Computer/Pi-----------e1.31 bridge-------Renard Universe 1
-------Renard Universe 2
-------e682
-------e682
-------e682
-------e682
At that point the bridge is maxed out with 6 ports. What I here suggested is the following:
Computer/Pi-----------e1.31 bridge----------hub (X ports)--------Renard Universe 1
--------Renard Universe 2
--------e682
--------e682
--------e682
--------e682
-------- X device limited by number of ports on hub
Do I have this right?
Mangrove wrote:I've got 20 SS24s and 5 48LSDs. I split this up over two universes and works well. I run DMX on all these controllers.Are you saying I should connect a network switch to the E1.31 bridge (using one port on the bridge) then connect the pixel controllers to the switch? I can see how that would yield a lot more capacity but are there any limits to the number of nodes connected to the switch?
You can have your two DMX outputs on the bridge and save the other four for other things. Install a small 5 port switch off the Pi with four going to the E682 and the last one to your bridge. Set this up with your PC and after it's working unplug the PC plugin the Pi. There are a ton of other options but I put it to you this way to help you understand based on your questions.
The E682's run directly off of you computer or Pi, but if you want more than one E682 you hook a switch up to the pi or computer and then run multiple. You can run a rennard network off either a serial port on a computer or you can run a renard network off of an of an E1.31 Bridge or an empty cluster on an E682. You do not need a bridge to run an E682. Most of us will setup a show network to make all of this easier to manage.

