I'm new to pixels and struggling a bit with the setup for my 2015 display. I've read the wiki and countless threads on the subject but alas I'm still confused.
I don't quite understand the setup of an E1.31 network. I'm used to the simple setup of running two of RJs DMX dongles from my show computer and from the dongles just daisy chain as many controllers as I need (up to the 512 channel max). This has worked well but I want to add pixels to the mix next year while keeping my LEDs.
So my plan is to add a E1.31 bridge from my show computer (but I also want to replace my show computer with a Raspberry PI). I'll use two of the ports on the bridge for the two universes that run my LEDs (eliminating the dongles). This is where it gets confusing for me.
There'll be 4 ports left on the E1.31 bridge. Right now I plan to use 4 sans devices E682s using the remaining 4 ports on the bridge. What happens if need more pixel controllers? I've used all the ports on the bridge how will I add more capacity? The confusing part to me is that the pixel controllers can't be daisy chained. I've read that some people use a network switch in their setup. Can/should the last port on the bridge be sent to a switch? If so is there a limit to how big the switch can be? 4, 8 or 16 port? Can I use more than 1 E1.31 bridge? If so, how is that configured?
I'm aware of the distance limits from the controller to the first pixel which is why I'm worried I might need more than 4 pixel controllers.
Thanks in advance for the help!
Maybe I'm over simplifying this, but for the pixel controllers using E1.31 you just need to connect them with a network switch or two. How many of your other controllers are using DMX and what boards are they?
If you are using 682's "I think" you can run DMX out on an output. I do it with Renard boards. So you go Pi to switch(s) and then to your E682s and then to your DMX boards. Someone can confirm if the 682 outputs DMX like it does Renard.
I've got 20 SS24s and 5 48LSDs. I split this up over two universes and works well. I run DMX on all these controllers.
Are you saying I should connect a network switch to the E1.31 bridge (using one port on the bridge) then connect the pixel controllers to the switch? I can see how that would yield a lot more capacity but are there any limits to the number of nodes connected to the switch?
What are your pixel controllers? E682's?
I run 2 SS24's 3 64HC's off of port 1-4 on the 682 as one universe. My pics are flashed with Renard firmware.
What I'm saying is you might be able to forget the bridge and send DMX out of the 682. If you run 2 682's I believe you could run 2 universes.
From the Sandevices website: Supports 2-wire balanced DMX outputs, compatible with standard wired DMX devices. Renard support coming soon.
So you shouldn't need the bridge. You just set your 682's up for Multicast or Unicast and designate the universe for your LED's and set up your 682 to grab that and send it out via port 4-1 and to your first board.
