Hi there - I have an E681 running a Pixel mega tree with 16 strands of 50 lights. This is powered by a 5V 300W Power supply. This year I'm adding an E682 for some additional pixels - final design not done, but i expect to run 10 more strands of 50. I'm wondering if I can make use of the same power supply, or if I should get another one. I was actually planning just to go ahead and get the second one, but I'm behind and price seems high ($50) so looking to save a few bucks. Thanks for any advice.
Without a doubt buy a second. You can find them cheaper or use an old computer PS. I would have back ups too, not to mention if you need more power for injecting.
Todd is sold out right now but offers these:
http://www.diyledexpress.com/index.php?main_page=product_info&cPath=20&products_id=60
Typical pixels draw about 0.06A each.
16 strands X 50 pixels/strand x 0.06A /Pixel = 48A Peak Current
10 strands X 50 pixels/strand x 0.06A /Pixel = 30A Peak Current
Total = 78A
A 300W power supply can only supply 60A max, so you do need a second power supply. There is a good wiki page about power supplies
thanks guys - i'll get the second one!
EMKLLK wrote:thanks guys - i'll get the second one!
If your interested in Meanwell brand power supplies see my previous thread here http://doityourselfchristmas.com/forums/showthread.php?38901-Anyone-Interested-in-Genuine-Meanwell-12v-350watt-29amp-power-supplies-(NES-350-12) I still have some 5v ones left.
Mr Smoof, any 12v left?
JEEPGUY wrote:Mr Smoof, any 12v left?
5v 12v and 36v not many though
Thanks Mr. Smoofy - i actually found one in my pile of unused stuff (sometimes it's nice to have a pile like that from past ideas that didn't work out)
