Send some pics of the landscape fixtures. In and out. We'll come up with some ideas and opinions!
--Jon Chuchla--
Sent from my iPhone using Tapatalk
Attached are a bunch of pictures that show my pathway lights inside and out. The original lights themselves have a 1.2 watt LED and are 44 lumens. I want my new RGB lights to be at least 80% of this brightness. As you can see in image 4, there is a rubber gasket that sits on the top deck and provides a moisture seal and a soft base for the glass to sit on. The opening in the base for the LED is small at just under 17mm. Regardless of what size light I end up using, I will almost certainly need to enlarge this opening. I probably don't want to go beyond the screw locations which is around 27mm since the glass needs a solid base to sit on. The black plastic connector that joins the top section to the post has an inside dimension of around 42mm and a divider at the midpoint with just a hole for the wire to pass through. My thinking is to have the pixel module mount in this area and enlarge the opening where the current LED is to around 27mm. I could use this 38mm pixel module instead of the 35mm one I posted earlier because the LED's are more centrally located. Link to 38mm module.
I would think that the module you linked would work well so long as it physically fits. Though it does seem rather expensive for what it is.
How about flipping it around? Instead of putting the light in the hole in the base where the existing one is, could you mount it to the top shining down? If you neatly run the wire straight up the middle you should be able to minimize the shadow. Maybe in some sort of tube to hold it in place. I'm thinking something like that threaded brass lamp shaft material. With the light on top shining down you've got room for a much bigger module. Probably 80mm or even 100mm.
You could even us the center shaft idea and use standard pixel strip mounted to the shaft. Perhaps 3 pieces of strip at 120 degree angles. Here's my quick idea mockup...
. That's three pieces of strip against a lamp shaft with clear shrink over it.
And the 5050s are much better than node style for this kind of application.
--Jon Chuchla--
Sent from my iPhone using Tapatalk












