Activity
 
Notifications
Clear all
reelpilot
@reelpilot
Reputable Member
Joined: Jan 2, 2015
Topics: 31 / Replies: 184
Reply
RE: Highest density Mega Tree anyone has built?

PaulB wrote:This year, our tree was 25-ft tall with 96 strands of 100 pixels this year (360-degree). At 60 watts per strand of 100, we are at 5,760 wa...

8 years ago
Forum
Reply
RE: My show is down! I can't figure out why my boards won't work.

plasmadrive wrote:If Renard is also RS485, it requires the same terminator.. however, I am not sure that reflections would be your issue since you see...

8 years ago
Forum
Reply
RE: My show is down! I can't figure out why my boards won't work.

plasmadrive wrote:So re-configuring to DMX from Renard on the Falcon fixed your issue? No the issue remains a problem and essentially everything bey...

8 years ago
Forum
Reply
RE: My show is down! I can't figure out why my boards won't work.

I had not heard of that, but I don't use a ton of DMX. In this case the Falcon was configured for Renard, not DMX, it just outputs from the DMX jack.

8 years ago
Forum
Reply
RE: My show is down! I can't figure out why my boards won't work.

I live nearby Javo's show and spent the afternoon yesterday working on a different approach to try and get his show running. Just to make sure all the...

8 years ago
Forum
Reply
RE: Loading FPP asking for password

Etcher also works for creating the image, so no problem there. It sounds like you might have the pi hooked up to a monitor and that is where you are...

8 years ago
Reply
RE: Loading FPP asking for password

Assuming it's a pi zero wireless just install the SD card with the image into the zero. It will boot and broadcast the SSID of FPP. Login to the hotsp...

8 years ago
Reply
RE: Pros/cons of Boscoyo "traditional" and "push-to-load" pixel mounting strips

Re: Pros/cons of Boscoyo "traditional" and "push-to-load" pixel mounting strips I used his newer style of strips for two seasons and did experience s...

8 years ago
Forum
Reply
RE: Odd pixel behavior on one port of Falcon

As was mentioned your configuration is not correct. You need to change the e131 setup. Currently you have the size as 150. The Falcon controllers supp...

9 years ago
Reply
RE: Odd pixel behavior on one port of Falcon

I have experienced a port go bad on the F16v2. The configuration page was quadruple checked, but to no avail. In my case nothing worked on the port an...

9 years ago
Topic
Replies: 0
Views: 929
Reply
RE: Long Thread Cable Gland

Kev7274 wrote:Dang good idea Phil,thanks. I did the same thing except with epoxy inside the hole of wood frame. It has worked great for two seasons ...

9 years ago
Reply
RE: Renard delayed response time

Ruppro wrote:I would swap out the TX 485 chip, U4, and try it again. I tired that with no luck and also replaced the pics just in case. In some test...

9 years ago
Forum
Reply
RE: Renard delayed response time

It was my first renard that was causing the delay issues with the second one. I swapped the first one out with one of my spares and everything was wor...

9 years ago
Forum
Reply
RE: Renard delayed response time

Ruppro wrote:Swap SS16s in the chain, put the second one that is delayed as the 1st one in the chain and vise versa and see if there is still a delay....

9 years ago
Forum
Page 1 / 15
Share: