Maverick45 wrote:Like the way that looks. Did you nail or screw 1x1? over nail pad of j-channel? How do you replace bad LED?
I get that , I just can't visualize how he did it. This is a very clean look and something I'd like to mimic, I just can't see how he did it from the first image to the finished installed look.
Sent from my SM-G386W using Tapatalk
Bump
Sent from my SM-G386W using Tapatalk
I know this is an ancient thread, but I am looking for options on a permanent eave install. This looks rather easy, albeit time consuming initially. Mount the pixels and attach the j-channel to the back of the eave. My only question is how does this look with the nodes facing down instead of out?
bigrednole wrote:I know this is an ancient thread, but I am looking for options on a permanent eave install. This looks rather easy, albeit time consuming initially. Mount the pixels and attach the j-channel to the back of the eave. My only question is how does this look with the nodes facing down instead of out?
Bigred... I'm new to the pixels this year. Thanks to information I've found around here and youtube, I found out about J channel and decided to go that route for the house trim. I went with pixels facing out for full exposure. I used aluminum J channel instead of vinyl as I have brown aluminum fascia and soffits. I also went with 2" spacing so I had close to 500 holes to drill for the front trim. Here are some pictures...
Front of House
Adding Pixels
Undershot of mounting at 90°, pixels, and wire tucked away
What it looks like at a 45° Angle
Test of clipping on a second piece to make it look solid
I'm trying to get a video together, but if you have questions, ask and I'll do my best.





