northernwarrior
@northernwarrior
Estimable Member
Joined: Dec 14, 2016
Topics: 19 / Replies: 106
Reply
RE: Questions for house outline on how to do runs. (Pic Included)

When I went from ground level to 2nd story my wire was about 15ft long. I had to stick a single pixel in the middle of the wire to the data could tr...

7 years ago
Reply
RE: Cheap DIY 12mm Pixel/RGB Mounting Strips

XmasinVancouver wrote:I did these last year with the grey plastic pipe strap sold at Rona. I'm in Vancouver. Where are you northern warrior? I did ...

7 years ago
Forum
Reply
RE: Cheap DIY 12mm Pixel/RGB Mounting Strips

020 wrote:I'm starting to prepare my Christmas lighting. Bought 100-Feet Strap for $15 and 7/16'' bit(about 11mm) for $3.49 from Amazon.ca using Pri...

7 years ago
Forum
Reply
RE: My house outline - Very much an amateur lol

g8rfn wrote:Watch my videos but just focus on the rooflines. You'll get a lot of ideas just by watching other people's sequences. There are tons 9f di...

7 years ago
Forum
Reply
Reply
RE: Can I request some better pictures or examples of j channel jigs?

I will post some pictures of my JChannel tonight, but instead of the pixels facing out, I have mine facing the house to make more of a wall wash effec...

7 years ago
Reply
RE: My house outline - Very much an amateur lol

g8rfn wrote:Do you have individual node control? Or are they strips? You can do a LOT more than u think if u have individual node control. Sent fro...

7 years ago
Forum
Topic
Forum
Replies: 10
Views: 13805
Topic
Reply
RE: Permanant mounting lights

stallionent wrote:I used this duct 1.5 x 1.5 So using the duct you linked to did you make the holes on the flat piece and mount the "U" part to t...

8 years ago
Forum
Reply
RE: Permanant mounting lights

Lightingfool wrote:I sent you a pm I didn't receive. Can you send again please ?

8 years ago
Forum
Reply
RE: Permanant mounting lights

Does it just clip together ? How much did the case cost and did it only do your garage ?

8 years ago
Forum
Reply
RE: Thoughts for mounting bullet pixels

I have had mine up through 2 Ottawa Winters and working like a charm. Rpi,picap,PSU are in garage and no issues with -40 degrees or just recently +4...

8 years ago
Forum
Reply
RE: Thoughts for mounting bullet pixels

dcamron wrote:How far from the house did you position those pixels? Maybe 6 inches. The channel is flush with the Eve's.

8 years ago
Forum
Page 1 / 9