I have an ESP8266 up and running 150 Pixel (450CH) driving ws2812b's.
I seemed to of fixed the assert issues, which seem to happen every 5 minutes ish.Its been running for 2 days solid and not crashed yet.
I am using E1.31 unicast UDP from vixen and running at 20Hz.
I have tested the speed and 50Hz is just about achievable with 450CH.
The overhead is in the pixel pumping, not the IP Reception.
It should be possible to pump 600Pixels / 1800CH at 20Hz, over 4 Universes. my next test.
But does it really matter, at £2 ($3) a device, even 450CH is a good implementation / buy.
I have also tested 2 universes of 450CH and performed universe selection in the ESP8266.
The device can receive broadcast messages from 255.255.255.255, so it should receive multicast, but I have not had this working. I think i have an issues with the router and multicast subscriptions. I need to read up on multicast and understand it better. A bit more( maybe alot more) investigation needed here. Time to get the wifi packet sniffer out.
I am not sure multicast is the way to go, it places a much larger overhead on the ESP8266, when much needed resources are required for pumping pixel data.
It has a few glitches in the WS2812b data stream, but I am not sure what is causing it yet. I could just be poor data line termination.
I need to do a lot more testing with much more traffic, to see how universes you can comfortably send over 802.11g. Anyone got any real life data?
The code is a real lash up, so I am not planning on releasing it yet.
The size of the module 25mm x 15mm.
The vero board behind it connects it to the ICSP / Debug Interface and not required in the production version.
There is a 3v3 Voltage Regulator soldered to the back of the ESP8266. The big cap ensure a nice smooth 3v3 supply. Before I added this, I had a world of pain..
I have uploaded a video here:-
Video of ESP8266 Driving 150 WS2812B's using E1.31 Unicast
Comments welcome.
Enjoy.
Ian
Re: World's smallest E1.31 Pixel Controller
Ian, looks nice!
Re: World's smallest E1.31 Pixel Controller - Just got smaller
This is extremely cool and great work. I'd be extremely interested in the following question you've asked;
"I need to do a lot more testing with much more traffic, to see how universes you can comfortably send over 802.11g. Anyone got any real life data? "
Since these modules are receive only, and using unicast, seems like the real issue is about how much traffic can these devices handle before becoming overloaded in throwing out packets not intended for the device...
At only $3 each I would be totally fine with only 450 channels (150pixels) limitation per controller :thup:
Do you have anymore information about how to set this up as I am in the UK and this looks quite nice for the price and seem easy to place in the display with it being so small
Regards
Stephen

