New pixel controlle...
 
Notifications
Clear all

New pixel controller

121 Posts
24 Users
0 Reactions
53.2 K Views
Posts: 911
(@madsci1016)
Noble Member
Joined: 12 years ago
sporadic wrote:I was curious how responsive the circuit you referenced would be, so I punched it into LTSpice and put a typical 2811 signal through it (1000ns high, 250ns low). Rise time was way too slow w/ the 10k's, but looks decent with a 220. Wasn't sure what rise and fall times were out of the ESP8266 so I used 20ns. Haven't replaced my scope yet, so I'm stuck to playing in LTSpice. Model is attached.

I used thesethese buffers on my PixelSticks and they worked great, SOT-23-5 part.


Logic Shifter - 10k by smerrick, on Flickr


Logic Shifter - 220 by smerrick, on Flickr

I got curious and did a real life test. The 10k resistors were worse than simulated, the circuit doesn't even level shift!

IMG 20150801 161248

Notice the 2 cursors, lower is 3.3V and upper is 5V.

Replacing the 10k with 1k at least shifts, but with bad rise time. Somewhere around 100ns.

IMG 20150801 161429

Then going to 330 ohm looks much better.

IMG 20150801 161853

So 330 ohm is definitely the way to go via the MOSFET shifting method. I've had a few GECE strings show a few artifacts with the diode shifting method. I'm going to try Mosfet with 330 ohm and see if the problem goes away.


Reply
Page 25 / 25
Share: