I am just wondering if there is a fix if using VSPI pins as D1 Mini SD card Shields use 18,19,23 & 5. I have pretty much the same problem. I have a g...
jchuchla wrote:Sorry if I came off as condescending in any way in that response. That was not my intent at all. Send me your profile (just need system...
holtm wrote:Not to take this thread off topic, but I wrote a some custom E1.31 code in PHP last year to control a sign using a RENESP. As I recall, on...
jchuchla wrote:First off. DONT DO THAT! The profile needs to be on a local hard drive (spinning or SSD, but not flash). If your profile is not on a...
5. Fix the bug, that asks if you want to remove colour filters when unpatching elements, then deletes them anyway, when you press NO. jchuchla wrote: ...
A button in the preview window, that once you have finished drawing your display, buys all the parts and build it in your garden for you, If at all po...
That looks complicated. Can you not just Zigzag it back and forth to the end? What is the max number of pixels per output? I have 720 Pixels, Start Bo...
I depends on what gauge cable you are using and the lengths, your plans do not show this. Also the number of pixel in each loop.
If the dumb strip are like the IP67 Silicone tube, the 1/2", if its the IP65 resin coating, then 3/8 would probably work. Although, Ii beleive the res...
mrGrumpy wrote:Not sure why you are trying to re-engineer this....Measurements have been made and that is the data you should use, unless you are doub...
I have a total of 24 arches, lit by 12 5m 12V 60/20 flex strips. I assumed 2.5M base on the comment above. AS 12 * 5M = 60. 60 / 24 = 2.5M So you St...
If its for just filming the Display, Drones are becoming stupidly cheap. I suspect the Cameras are rubbish. But, providing it will take the load of...
When it comes down to Full Load, there are 2 factors. 1. Can the supply actual deliver Full Load, You will have to test this. 2. How long can it susta...
Once you have set the Jumper and Configured the E682 for DMX on that Port. Map Elements to Channels as normal. Assuming you are using E1.31 Ethernet. ...
