need some info/help
 
Notifications
Clear all

need some info/help

18 Posts
10 Users
0 Reactions
6,557 Views
Posts: 22
Topic starter
(@mikech1984)
Eminent Member
Joined: 15 years ago

so with the ren px1 still in beta mode i will exclude that as a viable option for now. so what i am getting is that i am going to have to have two seral ports to controll two seprate boards. it also look s like i am going to need a power supply , a board to control the pixels, and of coourse the pixels them self. are there any good websites that sell the controllers and power supplys for pixels?


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago

Info about Power Supplies

Info about Controllers


Reply
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

The pixel control board could also be ethernet rather than serial. (I'm just sayin')

mikech1984 wrote:so with the ren px1 still in beta mode i will exclude that as a viable option for now. so what i am getting is that i am going to have to have two seral ports to controll two seprate boards. it also look s like i am going to need a power supply , a board to control the pixels, and of coourse the pixels them self. are there any good websites that sell the controllers and power supplys for pixels?

Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

An alternative would be to get an E68x type controller from sandevices.com and use the differential output from one of the connector blocks as an RS485 output to drive all of your Renards. That way the E68x would drive the pixels and your Renard at the same time. I find the Ethernet connection more reliable than USB overall.


Reply
sparky588
Posts: 248
(@sparky588)
Reputable Member
Joined: 17 years ago

my question is how you program it. Are there any videos on how this is don in vixen 2.0. i havent had any luck figuring out vixen 3


Reply
Page 2 / 4
Share: