need some info/help
 
Notifications
Clear all

need some info/help

18 Posts
10 Users
0 Reactions
6,567 Views
LightUpMA
Posts: 208
(@lightupma)
Estimable Member
Joined: 15 years ago
budude wrote:An alternative would be to get an E68x type controller from sandevices.com and use the differential output from one of the connector blocks as an RS485 output to drive all of your Renards. That way the E68x would drive the pixels and your Renard at the same time. I find the Ethernet connection more reliable than USB overall.

I was under the impression that dmx output from 68x was limited. Are you successfully using it?


Reply
Posts: 512
(@habbosrus)
Honorable Member
Joined: 14 years ago
sparky588 wrote:my question is how you program it. Are there any videos on how this is don in vixen 2.0. i havent had any luck figuring out vixen 3

You may want to take a look at HLS. It can do all very easily and handles large channel counts easily.


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago
LightUpMA wrote:I was under the impression that dmx output from 68x was limited. Are you successfully using it?

The E682 supports balanced line DMX perfectly with the only limitation that it can only address channels 1-510. Look at the last 2 pages of the E682 manual for more detail.

The E680 and the E681 support single ended DMX, not balanced line. You can use Budude's adapter to get balanced line DMX output from them.


Reply
LightUpMA
Posts: 208
(@lightupma)
Estimable Member
Joined: 15 years ago
jklingert wrote:The E682 supports balanced line DMX perfectly with the only limitation that it can only address channels 1-510. Look at the last 2 pages of the E682 manual for more detail.

The E680 and the E681 support single ended DMX, not balanced line. You can use Budude's adapter to get balanced line DMX output from them.

Ah that's why. I would have to upgrade my 681. And it would require more hardware. Maybe just buy a 682? Then of course I'd need more pixels hmmm .....


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago
LightUpMA wrote:Ah that's why. I would have to upgrade my 681. And it would require more hardware. Maybe just buy a 682? Then of course I'd need more pixels hmmm .....

Budude's adapters are cheap and simple, and they are a lot cheaper then a E682....
There is a wiki page about them.
I think Brian still has spare pcbs.


Reply
Page 3 / 4
Share: