The E682 can run 7 universes in multicast mode, 3570 channels or 12 universes in unicast mode,6120 channels.
A universe is 512 channels...(510 usable RGB)...or 170 pixels
It has 16 outputs so you can add multiple strings of pixels. The e682 also has a split output so 8 outputs can be 5v and 8 can be 12v and vise versa or all 5v or 12v. you can mix and match strings and chip sets.
This may be helpful
http://sandevices.com/documents/E682_Operating_Manual.pdf
Ok, thanks for all reply !!!
I have a last question please. What difference have uni or multicast mode ?
Unicast mode sends packets to a specific IP. The controller then only listens to packets destined for it's IP. Multicast sends out packets to all IPs. All controllers receive the packets and respond if the packets match up with the universe settings. Unicast equals less network traffic.
Sent from my LG-H811 using Tapatalk
Multicast is a "party line" (for those old enough to remember them) - Everyone listening and hopefully the one the information is intended for taking action.
Unicast (a private line) sends the information only to the IP address it is intended for.
Multicast is easier to setup as you just tell each controller to "listen to everything" and then act only on those universes/channels that are setup in it.
Unicast is a bit more setup work as you must tell the sending device (PC or FPP) where each universe is to go. Unicast cuts down on processing going on at the controller (not having to sort through all the data) and therefore usually puts that freed up processing to work with extra channel capability. For example, the SanDevices e682 can handle 7 universes (3,570 channels) in multicast, or 12 universes (6,120 channels) in unicast.
I would really like someone with a large display to chime in as to the affects of the large data stream in Multicast. Smaller shows do fine using Multicast.
I personally use Unicast on everything.
