Melted power input
 
Notifications
Clear all

Melted power input

12 Posts
7 Users
0 Reactions
3,331 Views
Posts: 50
Topic starter
(@blarson)
Trusted Member
Joined: 11 years ago

This is all really good information. I’m not sure how I would go about powering the pixels independently from the controller. I understand that I can only connect the data wire to each output on the controller, but I don’t know how I would go about running power from the power supply to all 16 outputs or 28 strands if I supply both ends. Is there a thread where I can see this done?


Reply
Posts: 50
Topic starter
(@blarson)
Trusted Member
Joined: 11 years ago

Here is a little video of the tree.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

You can power pixels from the controller but if you need to inject then run injection from you power supply or through a fused distribution board. Controllers are made so you can power pixels from them. That's why the outputs have a +V, -V, data and clock connections for each output. If your tree has 100-150 12 volt pixels running at 50% or less there wouldn't be a need to inject. I ran 55 up and 55 down at 25% and they looked great with no injection.

Sent from my SM-T710 using Tapatalk


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
BLarson wrote:This is all really good information. I’m not sure how I would go about powering the pixels independently from the controller. I understand that I can only connect the data wire to each output on the controller, but I don’t know how I would go about running power from the power supply to all 16 outputs or 28 strands if I supply both ends. Is there a thread where I can see this done?

You run Data and V- from EACH controller output to the start of each string (two wires not one, not three). At the power injection point (often the start of the string but really can be anywhere in the string) you connect two wires from the PSU and Two wires from the data source. For injection, the data wire goes to the pixel input. The V+ from the PSU goes to the V+ on the pixel string, the V- from the data run and the V- from the PSU and the V- from the pixel string all get connected together as close to the pixels as possible.


Reply
Posts: 13
(@pteller)
Active Member
Joined: 19 years ago

One of the manufacturers, I think Falcon, specifically warns not to use tinned wire on the high current connectors because according to them it prevents complete clamping and allows connections to loosen over time and heat cycles. There are cheaper options on Ali Express, but I bought this to have a variety on hand: https://www.amazon.com/gp/product/B01EUXLE8O/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1


Reply
Page 2 / 3
Share: