Melted power input
 
Notifications
Clear all

Melted power input

12 Posts
7 Users
0 Reactions
3,332 Views
Posts: 50
Topic starter
(@blarson)
Trusted Member
Joined: 11 years ago
[#53566]

I have a Alphapix 16 and one of the two power inlet lugs melted. 1) can this be fixed and if so where can I buy the little lug? And 2) what causes this and how do I prevent it from happening again? I’m kinda a noob to all of this so please forgive me.
Thanks in advance!


11 Replies
Posts: 376
(@k-state-fan)
Reputable Member
Joined: 16 years ago

Bad connection or to much draw. You can purchase the connecter and replace it.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Most likely cause is a loose connection. Terminals need to be screwed in very tight. Loose or weak connections produce heat.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Martins Opinion:

Do NOT power your strings from your controller. The only wires from the controller should be pairs of Data and V- going from the controller to the first pixel in the string. Inject power at the pixel string. I do this even with an 8 Pixel prop. Power is injected AT the prop.

If you follow the above you will almost never melt anything on your expensive controller.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Wire ferrules are the way to go.

Sent from my SM-T710 using Tapatalk


Reply
Page 1 / 3
Share: