Matrix Pixel Contro...
 
Notifications
Clear all

Matrix Pixel Controller recommendations.

6 Posts
5 Users
0 Reactions
6,027 Views
Posts: 2
Topic starter
(@archburger)
New Member
Joined: 7 years ago
[#52446]

Hello,

I have 2,500 12v WS2811 LED pixels and am needing a controller with the capabilities to make it all one matrix. I currently have an ESP8266 running WLED but it seems like there is a lag and stutter with the data running through the LED pixels. I am also using Xlights as my sequencing software.

Any controller ideas?


5 Replies
Posts: 242
(@hockeyhunter1956)
Reputable Member
Joined: 13 years ago

I'm always a little leery of answering questions like this because it really comes down to someone's preference. I'm currently running a Falcon F16V3 controller on my 4400 12v WS2811 pixel matrix and it works great. I'm using additional power supplies with the F16 for power injection on my matrix as needed. I've been happy with the F16 controllers and have 5 of them in my show. Again it's just personal preference and I'm sure others will have good suggestions as well.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

It is a SINGLE controller issue. You get visible artifacts in a matrix when any single string is greater than 680 pixels long. At 2500 pixels you should be using at least four ports on a controller. Get an F4 controller (wired solution) or at least 5 ESPixelStick controllers if you must be wireless.


Reply
Posts: 629
(@dkulp)
Honorable Member
Joined: 14 years ago

If you insist on keeping things Wifi, I would definitely suggest any sort of FPP based controller that could run in remote mode so the channel data isn't going over the wireless connection. 15 universes, while not a "lot", can definitely cause issues if your wifi network isn't a high quality and completely properly configured network. Doing channel data via wifi definitely requires more knowledge and work to setup for a reliable show than a master/remote setup.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Wled is a great choice !

As with any controller there are limits to how many pixels one should connect .
Have you looked at the Wled forums ?

archburger wrote:Hello,

I have 2,500 12v WS2811 LED pixels and am needing a controller with the capabilities to make it all one matrix. I currently have an ESP8266 running WLED but it seems like there is a lag and stutter with the data running through the LED pixels. I am also using Xlights as my sequencing software.

Any controller ideas?


Reply
Posts: 2
Topic starter
(@archburger)
New Member
Joined: 7 years ago

Thanks for all your responses.

I wanted to try and keep they it as simple as possible and after doing a little more research, we opted Falcon F16v3 and a Pi running Falcon Player. The matrix will be used as a ceiling feature in my nephews sensory room. He also likes to push buttons on devices, so we are also looking into using the falcon player script and event triggers for button inputs to the pi which would change the show for him on either the ceiling matrix or one a wall matrix we would install at a later date.


Reply
Share: