Notifications
Clear all

Level-Shifter

8 Posts
6 Users
2 Reactions
1,601 Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago
[#58594]

How do people feel about using (or omitting) 3V->5V level shifters between ESPxx modules and WS281x pixels? Any good (or bad) experiences without the shifters that can properly be attributed to their absence?

All of my training and experiences with designing for production tells me to rigorously observe the specifications detailed in the component specifications, but I'm designing for personal use rather than sales.

P.S. I already know what Ernie and Dirknerkle responses will be.


7 Replies
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Anything under 20cm has worked fine for me. I suspect the common mode noise rejection is horrible so any long distance or noisy environment is going to give you heartburn. For the most part, I use a Robg null pixel driver at the 10cm mark (length of wire on my jst connectors).


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

It's hard to argue with success. 🤔


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Hi, when running the ESP on 5V and only using outputs (no input voltages on GPIO’s) I use a pair of silicon diodes between the ESP and circuit 5V and 0V rails. The 0.6V / 0.7V reduces the voltage the ESP sees and moves the GPIO output’s (particularly the high logic level) to a more acceptable level.

Circuit 5V -> diode -> ESP (4.3V to 0.7V = 3.6V) -> diode -> 0V.

Note: It is possible to pull GPIO’s below the ESP’s 0V that is why I only use this for outputs.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
P. Short wrote:
P.S. I already know what Ernie and Dirknerkle responses will be.

Wouldn't you be surprised if I tried to do it the "right" way ?!?!?


Reply
Page 1 / 2
Share: