I am new around here but have been searching for a solution in the posts. I have a Kulp K4-PB that I have been playing with. I had everything working and suddenly it will not connect through the Ethernet dongle or the wireless antenna dongle. The display flashes a QR code to join its wireless network. That will not connect either. My router sees the Controller but I can't talk to it. During the wireless set-up I enabled the tethering mode. I have tried to turn it off w/ no success. At present the display reads Host:FPP ETH0: 192.168.1.96. FPPD is not running. then the KULP Lights graphic, it then flashes over to the WIFI HOT SPOT QR code. I am missing something I know. I have preformed a reset through the menu in the device and rebooted after every attempt. Can anyone shed some light on this, no pun intended lol.
Is 192.168.1.96 in your network IP range? Have you tried another SD card? I've had issues in the past and it was a corrupt sd card.
Kev7274 wrote:Is 192.168.1.96 in your network IP range? Have you tried another SD card? I've had issues in the past and it was a corrupt sd card.
I?m not real familiar with the whole IP range part but I have considered loading up a new card and trying that. The card came loaded with my controller but some of my actions could have corrupted it. I went into my router and allocated it to that Ip address. That was the IP the beagle was already showing on initial power up.
X-BATTERY wrote:I?m not real familiar with the whole IP range part but I have considered loading up a new card and trying that. The card came loaded with my controller but some of my actions could have corrupted it. I went into my router and allocated it to that Ip address. That was the IP the beagle was already showing on initial power up.
If your netwoek is say 192.168.0.xxx and the Kulp is on 192.168.1.xxx,then that would be a problem. I would try the sd card.
on your PC.
open a command prompt.
ipconfig
look for the IPV4 address. Is it 192.168.1.xxx? If not, that is definitely the problem. If so, what happens when you type 192.168.1.96 in your browser?
The line "FPPD is not running" is troublesome but first the networking fix.
Make sure your dongles are plugged in when the PB boots. You want them discovered on startup.
This is a case where the zoom room would be helpful because network issues when you are not network savvy are very frustratingly slow in the forum.
