Pixel Flickering
 
Notifications
Clear all

Pixel Flickering

14 Posts
6 Users
0 Reactions
2,592 Views
Posts: 8
Topic starter
(@adman110)
Active Member
Joined: 3 years ago
[#57251]

Hi,

I was wondering if anyone could help as I?m a bit of a novice?

Im having trouble with flickering LED?s (flickering between colours) only in one prop.

I have sketched a drawing of the set-up and will run you through it.

It is a window with pixels running round the edge. The green line is the data cable that controls the pixels (is the pixel cable) and the red is the power injection cable that is injected at the points arrowed.

A and B are 85 node spinners.

If I connect to the controller at point 1, Spinner B flickers (the whole prop)
If I connect to the controller at point 2, Spinner B flickers (the whole prop)
If I connect at point 3, spinner B doesn?t flicker.
If I connect at point 4, spinner B doesn?t flicker.

I have tried multiple things to troubleshoot the problem.
- re-soldered every connection
- At point 3, I have put a single node in-between the falcon controller and the cable, the single node works correctly and spinner B still flickers.
- I added the red power injection cable between the spinners as a test to see if it needed power but I kind of knew it wasn?t needed as power is injected at the end of the spinner A string.
- I also tried putting a Falcon F-amp at point 3 as the cable could be quite long across the bottom of the window, this didn?t work either. But I have many runs of lights with quite a few meters of cable longer than this and they work fine.
- I have also replaced the last 2 pixels on spinner A and the first pixel on spinner B, All results from above are the same.

Any ideas would help please.
Thanks for taking the time to read this and hopefully help me solve this problem.

IMG D63206750A20 1

13 Replies
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Make the wire between spinners a V- and Data only. No V+. Verify that the V- is clean. You are having a classic "too much current through the V- data reference wire" issue.


Reply
Posts: 8
Topic starter
(@adman110)
Active Member
Joined: 3 years ago
MartinMueller2003 wrote:Make the wire between spinners a V- and Data only. No V+. Verify that the V- is clean. You are having a classic "too much current through the V- data reference wire" issue.

Hi MartinMueller2003,
Thanks for reading and replying. I have just tried your suggestion with no luck. I still have the flicker.
I have also tried doubling the v- wire gauge. Also no joy

Have you got any other ideas?

Thanks


Reply
Posts: 120
(@superdave)
Estimable Member
Joined: 13 years ago

I would recommend watching a great video about flickering with pixels:

https://www.youtube.com/live/9ttEAyiyTAI?si=8K0YLIrkQh22oFbf

It could be a bunch of things, and he goes over a bunch of it.


Reply
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

Have you tried reversing A and B?


Reply
Page 1 / 3
Share: