Notifications
Clear all

Kulp K16 Max

4 Posts
2 Users
0 Reactions
421 Views
Posts: 13
Topic starter
(@jharding)
Active Member
Joined: 1 year ago
[#58924]

I just got a kulp k16 max with the beaglebone pocket2. I'm trying to set it up and I bought the USB wireless adapter, but the PB2 has a USB C jack. I have an adapter but I'm thinking I need to hardwire the LAN to configure the PB2 for wireless. Do I need the USB to LAN adapter as well?
As far as getting into FPP for config, is that all I need to do to get the controller up and running?

I'm not seeing much documentation online. I emailed Kulp lights as well


3 Replies
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

If there is no network but you have a working wireless adapter, it may go into hotspot mode so you can do the initial config using that. Turn it on with the wifi attached. After a bit, use your phone or computer to search for wifi and see if it appears.


Reply
Posts: 13
Topic starter
(@jharding)
Active Member
Joined: 1 year ago

I did not see the wireless pop up in my available devices. I did buy a LAN USB adapter and plugged it in to my router, but no lights come on showing links and I dont see any IP on the router. Since the PB2 is USB C, an adapter is needed right? Can be any USB C to standard USB adapter?


Reply
Posts: 13
Topic starter
(@jharding)
Active Member
Joined: 1 year ago

Figured this out. The wireless USB adapter had to be attached to a USB on the K16 board, not the PB2


Reply
Share: