I have these 12V WS2818 Dual Signal 4 pin pebble/seed pixels from Wu. There is no labeling on the cable except one of the our conductors has a black dot every 2 cm or so. The technical description says the following:
Working Input Voltage: DC5V or DC12V
Output Power: 0.1W/pcs led.
Emitted Color: WS2818 RGB IC,WS2818 Dual Signal,addressable RGB full color
Color Order: G R B (not RGB)
LED Space: 15mm/20mm/25mm/30mm/50mm/100mm/150mm/200mm pitch
LED quantity: one LED as one pixel(addressable);total 1000ct/string
Power injection: suggest to add voltage at every 100 LED
Wire color: 24AWG all Clear 4PIN wire (VCC+,DATA,Backup DATA,GND)
I assume the wires are exactly in the sequence as listed above, i.e. VCC+, data, backup data, gnd. The conductor with the black dots is 12V and the one on the opposite side is GND. The inner one next to VCC is the main data line.
Now with the Falcon Smart controllers v1.04 there is only G=Ground, D=Data and V=VC++. I thought the common practice was to tie both the main data line and backup data line together and connect BOTH to D on the smart controller. But now I am reading the main data line goes to D (as expected) and the backup data line should be tight together with GND. But I will lose the backup feature, which would make the backup line very useful. So what is the correct way to do this, for WS2818 strings?
I *think* the idea is that if you tie backup data to ground, the chip will see the BI line is 'dead' and make sure it takes its input from the DI line.
If you tie BI to DI it should also work, but there's a (rare) failure case that you could end up with an "off by one" issue if pixel 1 fails.
In other words, it doesn't really matter that much. That said I've never actually used this pixel type so YMMV
How would we know if these were worth the extra money? If the string fixes itself, how would you know that it failed?
Most 4-wire seed pixels (backup data) alternate the main data and backup data line every pixel.
Connect power, then try finding which one of the center two wires is main data input.
Some backup data seeds need the secondary backup data wire connected to ground at the first pixel. Others leave it disconnected.
Test with yours.
ErnieHorning wrote:
How would we know if these were worth the extra money? If the string fixes itself, how would you know that it failed?
Theoretically you'd have one pixel out or misbehaving, but it supposedly wouldn't cause everything downstream to fail.

