Joining WS2811 Stri...
 
Notifications
Clear all

Joining WS2811 Strings

8 Posts
6 Users
0 Reactions
2,861 Views
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago
gilv58 wrote:Thanks. I am looking at splicing some 12 mm bullet pixels not strips. I have read of the need to do power injection but I thought that only applied to 5 vdc and not to 12 vdc strings. I am planing on using heat shrink not only to individual wires but then applying heat shrink to all three creating a double insulation against water

Sent from my iPhone using Tapatalk Pro

Power injection also applies to 12V. The rule of thumb is every 100 pixels for 12V. In your case, just attach power at both ends of your 143 and 175 pixel strings and you'll be fine.


Reply
Posts: 15
Topic starter
(@gilv58)
Active Member
Joined: 14 years ago

Thanks I am just afraid that with voltage coming in from both ends of the string there may be a collision of electrons ..... 🙂 just kidding of course. Thanks for the good advice

Sent from my iPhone using Tapatalk Pro


Reply
Ronnie
Posts: 206
(@ronnie)
Reputable Member
Joined: 11 years ago
Keith R wrote: Just be sure that you are prepared to waterproof your joint.

+1 on this. I used dielectric grease on the solder joints and heat shrink over that and did not have a problem this (1st) year.


Reply
Page 2 / 2
Share: