channel mapping iss...
 
Notifications
Clear all

channel mapping issue i think

21 Posts
5 Users
0 Reactions
4,738 Views
Posts: 17
Topic starter
(@mrgimmeone)
Eminent Member
Joined: 10 years ago
[#44895]

i'm new to the whole pixels and controller and i must say it's feeling like it's well out of my league. i have 2 E682s first 1 for mega tree which seems to be working and 2nd is for my other 16 elements so far. the problem i'm running into is i can't seem to get the pixels to light up correct with each universe. universe 1 seems ok but when i try and test universe 2 in xlights 1-2 and 3-1 outputs both light up and it only gets worse as you go down the line. i'm attaching how my controller is set what my xlights setup looks like and the layout screen. dunno whats going on it looked fairly straight forward but from my missing hair it's far from it. i am also getting different colors on my pixels than what is programmed in my sequence dunno if they are related.

Screenshot (9)
Screenshot (11)
Screenshot (10)

20 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Your config is wrong on your controller , you have 16 ports configured with 170 pixels on each .

You can only use 12 ports @ 170 using Unicast .

Plus your start Universe #'s are incorrect .


Reply
Posts: 8
(@jnietzer)
Active Member
Joined: 11 years ago

Looking at your setup for the SanDevice, I notice that your output configuration repeats universes. For instance, outputs 1-1 to 1-4 starts at universe 1 channel 1 and ends at universe 4 channel 510. This is figuring there are 170 pixels per output. So for outputs 2-1 to 2-4, you would want to start at universe 5 channel 1 (where the first set of outputs ended). You only have 12 universes to work with, so you will need strings of less than 170 to utilize each output independently. Just make sure each output starts on the next universe/channel after the previous output and this should get you going in the right direction.


Reply
Posts: 17
Topic starter
(@mrgimmeone)
Eminent Member
Joined: 10 years ago

so each output cannot be used as 1 universe each to make 16.


Reply
Posts: 17
Topic starter
(@mrgimmeone)
Eminent Member
Joined: 10 years ago

so its a 16 channel controller but it only has 12 universes? so if i'm trying to run a small tree with 8 strings of 20 pixels totaling 160 pixels for the whole tree i would need to use the 1-1 and 1-2 outputs to run that 1 tree?


Reply
Page 1 / 5
Share: