Icicles with text
 
Notifications
Clear all

Icicles with text

24 Posts
13 Users
0 Reactions
11.4 K Views
Posts: 110
(@todd1814)
Estimable Member
Joined: 11 years ago
djulien wrote:BTW, those little PCB-ettes at the end of the icicles are here:
https://oshpark.com/users/current.523bd96f4bca6afb500007c5

The link doesn't work - takes me to my account. Can you try to repost it? I'm interested in the pitch on the strip.


Reply
SetMonkey13
Posts: 85
Topic starter
(@setmonkey13)
Estimable Member
Joined: 14 years ago

Looks great Don. I think I saw your video before and that's what inspired me.

Does seem like a big power user.

How do you deal with the data line?

Sent from my pocket using Tapatalk.


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago
SetMonkey13 wrote:Looks great Don. I think I saw your video before and that's what inspired me.
Does seem like a big power user.

How do you deal with the data line?

Sent from my pocket using Tapatalk.

I'm doing data like Plasmadrive, solder a wire to the data out at the bottom of the drop and run it behind the strip back up to the other wiring.


Reply
Posts: 2168
(@djulien)
Noble Member
Joined: 19 years ago
SetMonkey13 wrote:Does seem like a big power user.

How do you deal with the data line?

Power usage depends on how many pixels are on at a time and the color. These are 5V strips and I use an old PC power supply to drive each 8' segment of 300 pixels (max 4' away). I haven't noticed much on the electricity bill. BTW, effects like snowflakes or meteors actually have relatively few pixels on at any given moment so it is quite low power usage.

Data line goes from the end of each icicle back up to the start of the next (inside the silicon tune). I just used a strand of cat5 for that.

Data from the controller to the start of an icicle segment is a cat5 pair (data + ground). This works up to ~ 30' or so (longer than that requires null pixel or something like an RS485 differential driver).

P1320606
P1320603
P1320645
P1320680

todd1814 wrote:The link doesn't work - takes me to my account. Can you try to repost it? I'm interested in the pitch on the strip.

I wondered if that would work. Gerbers are at:
http://downloads.eshepherdsoflight.com/PexRenMini+Strip(ver1_1).zip

The source files are in ExpressPCB. Let me know if you want those.

don


Reply
Posts: 2168
(@djulien)
Noble Member
Joined: 19 years ago
djulien wrote:I will try to get the icicle construction technique written up in the next few weeks.

I finally got this written up. Article is at:
http://downloads.eshepherdsoflight.com/HowIdid-WS281X-RGB-Icicles.pdf

Also, Gerber files for those little PCB connectors are here:

http://downloads.eshepherdsoflight.com/PexRenMini+Strip(ver1_1).zip

don


Reply
Page 4 / 5
Share: