Are Gerber files the one used by OshPark?
Those look like 2" or 3" spacing. Correct?
Edit: Never mind. I see now where it was reported at 3.2". (I've got to stop skimming threads.)
algerdes wrote:I see now where it was reported at 3.2".
Yes - this gives 15 icicles (1 roll of 150 pixels) in 4 ft - just a convenience.
Skunberg wrote:Are Gerber files the one used by OshPark?
Yes. The .zip file contains the Gerbers I used for OshPark.
Here are is the source file, in case you want to modify it.
don
Not sure if I should chime in here, but this year I did the Plasma Icicles 2.0. They are all 16 pixels each (.5m long) and they are now a rigid PCB with the DO that comes back up the PCB and out the top. No more wire in the back. I used them this year and loved them. I had Ray make them for me with a cable for IN, OUT, and a PWR for every strip. I only power inject them every 8 drops but having the 2.5mm plug on every one allow for a lot of configurations. Ray makes them single or double sided. I use the single sided and they are only 38mA per pixel.
The best part for me was that I didn't use a lot of Ts, the connectors are smaller (cautions to be taken about moisture) Less power, and with the Falcon, I was able to drive a lot more in series.. That saved on my wiring. Of course my situation is not the same as everyone else's but if it is helpful, there you go.
Unfortunately I have gone dark for good regarding any front display for the public. I won't get to use them on my front eves any more.
