Help with E682 setu...
 
Notifications
Clear all

Help with E682 setup Please

8 Posts
5 Users
0 Reactions
8,028 Views
Posts: 230
Topic starter
(@oldandslow)
Reputable Member
Joined: 16 years ago

Thank you all for your thoughts. I will reconfigure my e-682 to run 8 ports of 90 pixels each. I will then use Xlights to do folds at 45 pixels as someone suggested to come up with my 16 strings of 45. I will run my power at 75%. This will come out as 720 pixels. I will do all this on the weekend and repost with a thumb nail picture.
Thanks to all
John


Reply
Posts: 230
Topic starter
(@oldandslow)
Reputable Member
Joined: 16 years ago

Thanks to all. I redone the E-682 and all is well set it up in xlights and it does what I programmed it to.

I do have one question what does the millisecond number should be on the controller? I left it on 250 and it seems to work ok.


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago
oldandslow wrote:Thanks to all. I redone the E-682 and all is well set it up in xlights and it does what I programmed it to.

I do have one question what does the millisecond number should be on the controller? I left it on 250 and it seems to work ok.

It's actually a microsecond number. The microsecond number is the time required to reset the chip in the pixels. If reset timing is too short, the pixel won't update properly to the next instruction. Old pixels had a very short reset time of about 50 microseconds. Newer pixels require a minimum reset time of 280 microseconds. Set this number to 300 to make sure you don't have issues. The longer reset time setting works fine for older pixels, too.


Reply
Page 2 / 2
Share: