I would just do the zig-zag in software (x-lights? Vixen?). So uncheck all the "reverse" check boxes, and fix your starting channel for group 2 universe=23, channel=61
oldandslow wrote:I am running a small mega tree of 16 strings of 45 pixels.
The actual length is 4 stings of 90 pixels and I zig zag at 45 pixels.
I uploaded my setup page to look at and tell me if I have it setup right with my E-682.Thanks for your help
John
So I see a couple of issues. First, your second port should start at Universe 23, channel 61 (not 1). Second, depending on your percentage of power output, I hope you are planning on using power injection, because I don't think you can push that much power over 360 pixels with out it. Third, I think there is a limit of 6120 channels on the e682 unless that has been updated. With your two ports you are already pushing 2160 channels. Unless you are planning on using all of the ports, channel counts may come into play. Also I notice there is a problem with the ending channel. You need to update the universe numbers so that you have enough room (i.e., universe 24,25,26, etc.) for all of your channels.
Good Luck!
You should also update your E682 firmware to version 5.030. It allows you to separately control each output rather than as groups of 4.
Agreed - update the firmware to version 5.030.
The E682 can handle 6,144 channels (2,048 3-channel pixels) in Unicast mode, or 3,584 channels (1,194 3-channel pixels) in Multicast.
You can assign all of those channels to just a few outputs, or spread them out among all 16 outputs.
Set the number of channels per individual output, then set the number of channels for each zig-zag on that output.
The E682 is a workhorse for us. 6 of our megatrees, and a couple of other locations, are driven by E682s. They have driven these props for 5 years now, with no problems.
