Hacking LED Strings...
 
Notifications
Clear all

Hacking LED Strings from DX

44 Posts
8 Users
0 Reactions
11.4 K Views
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

Bicycle inner tubes.. (was discussed in another forum earlier this month)


Reply
Posts: 92
(@macshroom)
Estimable Member
Joined: 13 years ago

I wish i had taken the advice and blobbed inside the 8ch box.i really really wish i had done that.the wind is destroying my rectifier connections.ive repaired a half dozen and i havnt powered on my system yet. Just saw them through their plastic bag protection,that they were broken.the wee white boxes offer the perfect protection.just twist tie a baggie over them and they are perfect.
So much money and time wasted adding rectifiers instead of blobbing in the old boxes.
Next time,i blob.next year,ill blob all my new strings.
That was great advice but after reading all the other posts and the wiki, i thought adding a new rectifier was the way to go.
I was wrong. For me anyway. For me and the way i have things and where i live.iit was a poor decision. should have taken your advice.
Thanks man.


Reply
Posts: 1076
 Zeph
(@zeph)
Noble Member
Joined: 15 years ago
LabRat wrote:
FYI.. if you have a "simpleREN" or "ren64", you could wire up control lines to each of the four channels. Then you would have a four channel LED string. (More options for blinking/control)

LabRat, could you elaborate on this option?

I have a Ren64. As I understand things, it sends 4 logic level signals out on each cable, intended for a 4 channel SSR. The SSR would have a logic level input optoisolator driving a Triac.

Would controlling this light require using an optoisolator for each channel? And where would I hook it into the circuit?

Thanks for any brainstorming on this option. I do think individual control as you suggest would be interesting.


Reply
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

If you look at the image I had poster earlier the yellow bar is connecting four pins to the pin on the right (which I believe to be ground).
So in theory pulling any one of those four to ground, would turn on the 1 channel.

Yes.. we would typically put an opto-isolator in series with your signal from the REN (to be safe). In the case of DC the isolator drives a MOSFET (or lower current transistor) instead of a TRIAC (used for AC). As we discovered upon review of your box, it appears to already convert the incoming AC to DC. So basically you would poach the opto circuit from a DCSSR, and route the control line to those four pins in your existing controller board.

Did that make sense?

Zeph wrote:LabRat, could you elaborate on this option?

I have a Ren64. As I understand things, it sends 4 logic level signals out on each cable, intended for a 4 channel SSR. The SSR would have a logic level input optoisolator driving a Triac.

Would controlling this light require using an optoisolator for each channel? And where would I hook it into the circuit?

Thanks for any brainstorming on this option. I do think individual control as you suggest would be interesting.


Reply
Page 5 / 5
Share: