I am running pixel strings using 63 pixels per string. I would like to power the strings from the end as well as the beginning. Since the strings are running end to end consecutively, I spliced the power in from the start of the new string (and left the clk unattached) to the end of the previous. When I set up the pixels, they didn't seem to work properly so I removed the power injection from the ends of the strings. (And of course get the "red pixel syndrome" due to voltage drop at the end, when on full white).
Is it not recommended to use the output connectors on the E681 for additional power? Should I run the power directly from the power supply and fuse the connector?
Sent from my iPad using Tapatalk
What I have revised for this year is running a higher amp power supply (2 60A's per E68x) and adding an extra ground lead. Most of my GECE's are between 40-61 pixels in length. Last year I used a four conductor cable using data, ground, and 2 power wires from the e68x (both wires fed from the fused board connector) . I then run the second power wire to the end of the string to inject power. What I have changed for this year is add a separate ground wire back to the controller. I did not have any real problems with pinkish bulbs, but I believe this year i should not have any pinkish lights. At least I hope so.
This year is my first time using these GECE lights, I'm going to be using 1 70amp power supply since they come with a 3 amp per string of 50. 3x16=48amps, I can't see the e862 using 22amps. Is there something I do not know?
have too much voltage drop from your splice most likely....do a run straight from the PS
