At 100% white output I get flickering in my pixel rings (see video). Upon closer inspection the flicker seems to actually be intensity spikes while I'm doing rising intensity effects. If I hold it at 100% it doesn't occur, but everyonce in a while all rings will blip dark. In this particular video the flicker only happens on the outside rings of the larger circles, but it regularly happens to all of them. Any other color with any other type of effect is produced flawlessly, so far as my eye can tell anyway.
WS2811, 12VDC, RayWu 18AWG pixels.
F16VR2 is handling the two larger circles.
E682 is handling the middle smaller circle. I used to run the larger circles on the E682 and the result was the same. I was actually hoping my new F16VR2 would clear it up, but that's not the case.
For each of the three circle assemblies (left, middle, right):
I'm driving the two inner rings off a controller output direct. (42 pixel ring in series with a 60 pixel ring)
The two outer rings are power injected with just data coming off controller output (78 pixel ring in series with a 95 pixel ring, the middle circle doesn't have a 4th ring).
I originally did this split in terms of the data line because I could not get it to drive rings 1, 2, and 3 in series. One person told me that should not have been the case.
Where needed I use those heat shrink/solder in one tubes for splices.
This is not the end of the world as 98% of the rest of the time the effects are jaw dropping (especially at 2ft viewing distance currently), but I've spent so much time on this. Thanks for any consideration ahead of time.
https://www.youtube.com/watch?v=fWb_FPevGjA
My gut feeling is this is a data issue. Do either of the two controllers you have feature a white ramp test pattern?
If either of them do, and the problem still persisted that would rule out software being the issue. You can also try a different application to see if the problem goes away.
I noticed in the video that it appears your data lines all follow the same "spoke" and run next to each other. Have you tried separating them? What's the distance you're running these from the controller?
If you're able to, can you just run one of the rings by itself with the others not connected, or just connect a extra string of the same pixels to the controller to see if you still have the issue.
Just throwing some stuff out there for you to try to help narrow down what's causing the problem.
You should have ground coming from the controller too aswell as data in sure I have read your correct and your only taking data from the controller
Ws2811 use the ground as a reference
Did you ever find out what the cause of this was? I thought it was just me, because I hooked up some icicles tonight, and got the same behavior you described.
I'm using F16VR2 and WS2811, 12VDC, RayWu 18AWG pixels.
Mine was actually a WIPE effect. Wipe to full white, and I get a brief FLASH to black. If I hold steady at 100% white = no problem. Every other color and effect = no problem. It seemed to only be an issue in the transition to full white.
Now granted - I was testing with 152 pixels without any power injection, so I'm assuming it's a power issue. However, typically power issues for me have presented as dim\pink pixels - not flashing white, which is typically more indicative of a data issue.
Very strange indeed.
No, never made much headway. I broke up the two outer big rings on each circle and it still does it. I think it's probably something with the data line. I even broke up the two outer rings into their own outputs and it still does it.
Now that I revisit this StickyWicket has some interesting simple tests I should try. I definitely don't think it's software.
As a 1st year-er I've had a mountain of work so I didn't dive too deep here.
Sent from my iPhone using Tapatalk
