Notifications
Clear all
StickyWicket
StickyWicket
@stickywicket
Honorable Member
Joined: Nov 23, 2012
Topics: 29 / Replies: 519
Topic
Forum
Replies: 2
Views: 1938
Reply
RE: Configure multiple DMX moving heads off one port

I think I figured this out. I had head 1 to address 1 and head 2 to address 2. I changed head 2 to address 17 (these are 16 channel heads) and I now...

3 years ago
Topic
Reply
RE: Looking for icicle lights

DILA wrote:Looking for 3-4-5-4 drop icicle lights, 4" between pixels 8" between drops. I found some on Aliexpress but almost $400 for a dozen 64 pixel...

4 years ago
Reply
RE: Decrease Number of Power Supplies

First thing I?d do is decrease brightness. There is very little difference between 50% and 100% to our eyes but power is directly proportional. I wo...

4 years ago
Reply
RE: Stream show on Twitch

I tried a Facebook live and they muted the audio before my live was even over. The only site I have used is Vimeo. They haven’t taken down any conten...

4 years ago
Reply
RE: Most efficient way to power multiple power supplies in an enclosure

Marci wrote:Ha! Nice. Do you know if I can power an F16v3 with 2 separate power supplies? Is this allowed or do I have to power both sides with the s...

5 years ago
Reply
RE: Show Me Your Unicast Channel Output Settings for ESPixelsticks With Multiple Universe

I just define two full universes. You can do it either way though. I think I did it this way in case I wanted to add more pixels to either controller...

5 years ago
Reply
RE: Show Me Your Unicast Channel Output Settings for ESPixelsticks With Multiple Universe

Outputs 14 & 15 are multi-universe unicast to ESPixelSticks. 16-18 are also ESPixelSticks but only 1 universe to each.

5 years ago
Reply
RE: Bluetooth Vixen to Arduino?

I don’t think what you are trying to do will work. I could be wrong, but I don’t believe Vixen will work with Bluetooth.

5 years ago
Forum
Reply
RE: Interesting Problem / Easy solution

Did you by chance measure the voltage (DC) on the power supply? Dimly lit red pixels is a good indicator of overvoltage.

5 years ago
Reply
5 years ago
Forum
Reply
RE: Hello, McFly?

Just to clarify usually you need a network switch between controllers and PC. You can’t just connect the controller directly to the PC.

5 years ago
Reply
RE: lower intensity

If you are using FPP you can install the brightness plugin and lower it that way.

5 years ago
Page 1 / 37
Share: