Control standard le...
 
Notifications
Clear all

Control standard led lights with alphapix controller

12 Posts
5 Users
0 Reactions
4,302 Views
Posts: 69
Topic starter
(@parkej60)
Estimable Member
Joined: 11 years ago
[#42395]

I have a mixture of RGB pixel lights and standard Christmas light strands. I'm looking for a good approach to handle controlling the standard lights strands from an alphapix controller output. I feel like I could just cut off the ends and run the power and ground lines and leave off the data? Is that correct? Any direction or suggestions are greatly appreciated.


11 Replies
Posts: 383
(@aesl1982)
Reputable Member
Joined: 12 years ago

U need to run them off the Dmx rs-485 ports with a ac controller. Like the Lynx express, LOR controller. If you use the Lynx then no cross over cables or anything tricky are needed

Sent from my iPhone using Tapatalk


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I am not sure what you mean by "standard" lights. That is not a term regularly used here. Do you mean Dumb RGB? Those have four wires. Do you mean the LED strings that you can plug into a wall outlet? Those do not run on the same type of power your RGB Pixels are using. A bit more information will help us to be able to better help you.


Reply
Posts: 69
Topic starter
(@parkej60)
Estimable Member
Joined: 11 years ago

As for standard lights I'm referring to a traditional strand of incandescent lights that you would typically plug-in to a wall outlet. Thanks for your responses!


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

pixel controllers will not control incane/led string right from it have too have a ac controller and that can connect too the dmx output of the alpha and run the strings

Parkej60 wrote:As for standard lights I'm referring to a traditional strand of incandescent lights that you would typically plug-in to a wall outlet. Thanks for your responses!

Reply
Page 1 / 3
Share: