Using a T with Powe...
 
Notifications
Clear all

Using a T with Power Injection

6 Posts
5 Users
0 Reactions
2,667 Views
Posts: 50
Topic starter
(@a2k97)
Trusted Member
Joined: 19 years ago
[#42392]

I wanted to share a diagram I made to help me understand my layout, and to make sure I have everything hooked up correctly. This is obviously specific to my setup, but I think it can be easily applied to others. I think this diagram will help new pixel users, as I am, to understand using a T. I had seen the diagram in the wiki, but it didn't make sense to me. I wrongly assumed, despite the diagram, that all 3 ends of the T were connected straight through. Not until I physically got one, and tested it with a multi-meter, did I actually grasp what was going on. And I am glad that I did, because my original layout had me using the T incorrectly, and I would have fried something because I would have connected the data line to the V+ line.

This is for a matrix comprised of 12V, 50 count strands. I plan on doing power injection every 100 pixels. The T's are from DIYLEDExpress, but you should obviously check yours with a multi-meter. The solid lines represent the wires inside the 3-wire conductors which are also from DIYLEDExpress. The dotted lines just represent the actual connection between the male and female connectors.

The wire colors are accurate to the wires that are inside the conductors I purchased. Yours may be different. The green wire is actually green/yellow, but close enough.

So hopefully this is helpful to someone, and if it's totally wrong let me know.

This is a great site, and thanks to everyone who posts on here.

Andy

T Layout

5 Replies
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

I am using 4p connectors for power. I use 3 pin for data lines. This does a few things...
1. Its impossible to plug a 4p into a 3p connector thus preventing any possibility of toasting anything by plugging a PI cable accidentally into a DI/DO connector.
2. 4p gives me two grounds and two V+. That way I can supply from 1 or 2 PSUs.
3. I can select which way the power goes out of the T. Back only. Forward only or bridged.


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago
Wolfie wrote:I am using 4p connectors for power. I use 3 pin for data lines.

Are you using any 4 wire connectors for anything other than power injection?


Reply
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

No.


Reply
Posts: 114
(@wilkija)
Estimable Member
Joined: 12 years ago

So how would you (if possible) use the T connectors if you screwed up the wiring and had the pigtails as green for ground, blue for data, and brown for voltage? I didn't realize they weren't straight through until I read this post. I realized after I wired lots of pixels last year, that I didn't follow the standard. However, it didn't matter because I didn't use any tees for power injection. This year I do plan on using the tee, or had been planning, but I already have several hundred strands with pigtails attached using the blue for data and green for ground.


Reply
Page 1 / 2
Share: